Rißprüfung zerstörungsfreie Werkstoffprüfung / Rissprüfung

Programmierung zum Festpreis
Hydro Steering Racks

Automatic Crack Inspection for
Hydro Steering Racks

by means of a Rotating System

Crack Specification :
Depth :
Width :
Length :

50µm
80µm
 3,75 mm

The steering racks are tested along the even shaft after the last surface finishing.
The parts are dry and washed.

Test speed: 200mm/sec.
Test rate: ca. 600 parts/hour
Continuous tracing with 2 channels
 Blanking out of the toothed area and piston location
Careful transport of the parts by means of servo drives
Non-contact crack inspection, no wear oftest and rotating head
Retrofitable by pattern and hardness test(eddyliner®P16 for multi-position tests)
Crack inspektion device

Crack inspektion device with a view on the operating side Steel cabinet for test instrument Rotating head in maintenance position
Rigth:
feed and escapment
of parts
Middle:
Rotating system
Left:
Sorting gate for O.K. parts and n.O.K. parts

Rotating head with precise part guiding. The driven profile rolls are adapted to the diameter of the steering racks.
Rotating head

A good guiding mechanism of the steering racks is achieved by the short overall length of the rotating system. Here you can see the feed of the rotating head. The connecting parts of the probes as well as the rotation monitoring and motor are clearly indicated.

[Homepage] [Advantages] [Products] [Applications] [Economical] [References] [ibg worldwide] [Press] [Contact]

Impressum / imprint / Impression / Impresion
 © 2002 ibg Prüfcomputer GmbH, Pretzfelder Straße 27, D-91320 Ebermannstadt, Tel: (+49)-(0) 9194/73 84-0 Fax: (+49)-(0) 9194/73 84-10